View Single Post
Old 05-23-2013   #5
Dynomite
 
Dynomite's Avatar
 
Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,817
Default Re: Removing Cam Cover Bolts the Hard Way

This my 90'.....my 91' is full PCed.

I want this up and running this next week and I figured I can always PC later.
Actually just experimenting with Rustoleum Silver (high temp)

Plenum looks great with red letters. Will post photo tomorrow.

SW complete offroad exhaust and SS intake
Air box also here next week (George Braml)

Since I have C Frame disconnected also installing ZFdoc C Frame plates.
Keeping secondaries so I can say I know how to maintain them on this 90'
And New Water pump and Randy's aluminum pulleys.

Did the usual differental drain install and the usual TB coolant elimination to make those Plenum pulls a 30 minute job

Also experimental Belt Tensioner Pulley.
Already have nice new aluminum radiator it turns out I did not know about when I got this 90'

Last edited by Dynomite; 05-24-2013 at 12:00 AM.
Dynomite is offline   Reply With Quote