View Single Post
Old 07-30-2012   #3
secondchance
 
Join Date: Aug 2006
Location: McLean, VA
Posts: 3,738
Default Re: Flywheel install and tec..., etc..., etc...

Quote:
Originally Posted by scottfab View Post
Great pics. I hope you clean out the drain hole for the V while there.

You say the rear beam plate bolts were loose. Do you think they were just put in loose or did they loosen over time ? (shifter movement was ok at first then got worse?).
Drain hole was cleaned about 2 months ago when I replaced the starter at Jim's.
After removing the starter the recessed box area was sprayed down w/ Brake Clean spray (2-3 times) , followed by Simple Green (again about 3-4 times) followed by a final rinse w/ boiling hot water from Lyndi'd kitchen. All cleaners drained freely through the drain.
Rear beam bolts when installed the last time (about 4-5 months ago, I think) were finger tightened and forgotten - silly me!
secondchance is offline   Reply With Quote