ZR-1 Net Registry Forums - View Single Post

Paul Workman · 06-11-2012

Ya know...Looking at the pilot bearing, it looks to have been cast with the hole centerline off-set, based on the three little satellite dimples surrounding the hole. Installing the transmission might have been interesting - especially getting the trans bolts to line up with the bell housing. I would think there would be some serious tweaking to the input bearing at the very least!

Wow!... That's pretty amazing!

P.

06-11-2012	#5
Paul Workman Join Date: Nov 2007 Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri Posts: 6,466	Re: Clutch and Flywheel Wear Pattern Ya know...Looking at the pilot bearing, it looks to have been cast with the hole centerline off-set, based on the three little satellite dimples surrounding the hole. Installing the transmission might have been interesting - especially getting the trans bolts to line up with the bell housing. I would think there would be some serious tweaking to the input bearing at the very least! Wow!... That's pretty amazing! P.