[HAWAIIZR-1]

Originally Posted by Aurora40

That's what I did, I used the clamp as a guide. The edge was pretty straight, at least appearance-wise. It can still end up being crooked in that the bottom is shorter or longer than the top of it. Though I think if it's totally even, it still can end up crooked when installed, as there is an angle between the air horn and the air box.

It's basically a big pain. So make sure it's really pissing you off enough that you just have to trim it...

Thanks Bob! I'll measure twice and cut once if need be. I noticed it is best to trim a little from both side if true even is desired. I'm going to test fit the SLP and see how much difference from the other cold air one that is a pain to get lined up right. I know what you mean about the SAMCO and if my stock one with the stiffener was not in my long term storage while overseas I would put it back on. It is quite thick so I was not sure how it would do cutting with the xacto blade or one of those other cutters that you can break off new blades. Thanks again for your input.