Quote:
Originally Posted by Dynomite
Well........... 
Aside from explaining step by step.....did you bend some contact points back into place? Did you have to use a solder gun to build up any worn areas with new solder? Could all parts be mechanically broken down (screws or bent tabs)  |
All I did was pull the switch apart and fix the contacts. they need to be bent a bit to get the cylinder to work correctly.
As for pulling it apart, not for a while, all I am doing is replacing a couple bad speakers and fixing the ribbing on the Passenger side door panel (drivers is done) and then enjoying the car..
Next week is Bloomington Gold and I am going with the car..