Re: Clutch Pressure Plate Bolts
Quote:
Originally Posted by jpgolf14
Back from the dead.
Hi guys, I'm new to the forum and do not own a ZR1 Vette. However you guys do have the best info on this LT1 pressure plate bolt fiasco.
I am putting an LT1 T56 trans into my '87 IROC. And I finally found a place that seems to have the correct bolts. McLeod part number 1502.
However my problem is my nice new SPEC steel flywheel does not have the counterbores in it. So does anyone know the diameter of the counterbores in the stock flywheel? Is it just 3/8"? I am going to take the flywheel to a machine shop to have the counterbores drilled.
Thanks,
John
|
Please refer to post #4 above foor the bolt dia. Counterbore size would be as close to 0.376" as you can reasonably get. The tighter the "slip" fit, the better.
__________________
Jerry Downey
JERRYS LT5 GASKETS & PARTS
http://www.jerrysgaskets.com
1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc.
2016 Black-Red, 3LT-Z51 Auto 8-speed.
|