ZR-1 Net Registry Forums - View Single Post - Saturday 2/12 Gathering...expert help needed>>>

secondchance · 02-10-2011

Guys,

Since Michael did not remove the "C" beam, best way to install plate is to support the trans, unbolt front w/o pulling the bolts out, place the plate and get the thread started for 2 bolts. I believe front bolt torque is 40 ft-lbs. For the rear, it would be similar procedure but the torque is 60 lbs, I believe.

More challenging will be installing the new exhaust w/o leaving excessive (any since it's Michael) fingerprints.

02-10-2011	#4
secondchance Join Date: Aug 2006 Location: McLean, VA Posts: 3,730	Re: Saturday 2/12 Gathering...expert help needed>>> Guys, Since Michael did not remove the "C" beam, best way to install plate is to support the trans, unbolt front w/o pulling the bolts out, place the plate and get the thread started for 2 bolts. I believe front bolt torque is 40 ft-lbs. For the rear, it would be similar procedure but the torque is 60 lbs, I believe. More challenging will be installing the new exhaust w/o leaving excessive (any since it's Michael) fingerprints.