ZR-1 Net Registry Forums - View Single Post

Twinmags · 06-13-2006

I had to replace the rubber T on top of the PVC valve with a new one. I did that, started it up, turned over fine, but idled badly and blew some smoke for a few seconds then the SES light came on and then she idled fine with no smoke like normal no bad sounds and at the regular RPM. So I checked the codes again and it was still showing a 33. Disconnected the battery for one minute to clear the code and started it up again and it did the same thing. Anyone got any answers?

06-13-2006	#1
Twinmags Join Date: Feb 2006 Location: Tulsa, OK Posts: 8	SES Light I had to replace the rubber T on top of the PVC valve with a new one. I did that, started it up, turned over fine, but idled badly and blew some smoke for a few seconds then the SES light came on and then she idled fine with no smoke like normal no bad sounds and at the regular RPM. So I checked the codes again and it was still showing a 33. Disconnected the battery for one minute to clear the code and started it up again and it did the same thing. Anyone got any answers?