Those with FIC injectors
 

since they are shorter, what if anything did you do different when installing?

There is 2 grooves on the top, which did you use for the clip?

Just verifying what I did, I think all is good, but don't know yet

Re: Those with FIC injectors
 

Have you started that beast yet ? The set I had only had one grove for the clip. What set did you end up with?

Re: Those with FIC injectors
 

a set with 2 Grooves.. LOL

one groove looks to be for the clip.. the other sets the O ring a bit low for me, but might be okay

Yes Started it this Am.. idles great.. cleaning up garage tomorrow and going for a drive

Re: Those with FIC injectors
 

What about Lake Mills in the morning ?

Re: Those with FIC injectors
 

too far to drive if I have issues.. gonna just drive around the area.. that will not be to later in the day though

Re: Those with FIC injectors
 

Come on dont tell me your questioning your skills in Z repair :icon_scra. . . You'll be in good hands with Lee and Hans.

Re: Those with FIC injectors
 

Here's a few pics from last year when I did the FIC injectors. The four slots that hold the rail down to the IH's had to be oblonged upward about 3/8".

out with the old...
http://i43.photobucket.com/albums/e396/ry368/zr1415.jpg
http://i43.photobucket.com/albums/e3.../zr1415009.jpg
http://i43.photobucket.com/albums/e3.../zr1415010.jpg
in with the new...
http://i43.photobucket.com/albums/e3.../zr1415011.jpg
http://i43.photobucket.com/albums/e3.../zr1415013.jpg
http://i43.photobucket.com/albums/e3.../zr1415012.jpg

Re: Those with FIC injectors
 

not at all.. my concern is the Injectors.. remember the issues last year?

Re: Those with FIC injectors
 

I should also add that I had to push the dimple next to the screw on the injector bracket inward with my vice to allow the bracket to sit flush against the rail after oblonging the screw location.
http://i43.photobucket.com/albums/e3.../zr1415014.jpg
http://i43.photobucket.com/albums/e3.../zr1415016.jpg

Re: Those with FIC injectors
 

Looks like a differing view on the install here... with the FIC Bosch injector package this note is included:
http://i17.photobucket.com/albums/b7...jectorclip.jpg

Thus when looking at the FIC injectors note top "full circumference slot>>>
http://i17.photobucket.com/albums/b7...ryinjector.jpg

Thus when installed looks like this>>
http://i17.photobucket.com/albums/b7...nfuelrails.jpg
http://i17.photobucket.com/albums/b7...orscloseup.jpg

Also for those who use a different brand (like Accel) injector and hear about 'grinding off the tab' here is what is meant (did this for Glenn's car when we replaced his injectors)>>>
http://i17.photobucket.com/albums/b7...tabremoved.jpg