Hurst Shifter
 

I've purchased a Hurst shifter for the ZR-1 and need a little advice on installation of the shifter. I remember seeing a Thread sometime in the past showing how to install it, but can't find it. Any help would be much appreciated.

Re: Hurst Shifter
 

One, open the box and make sure the bearings are in the shifter. If they are not, let me know and i'll give you the Timkin bearing number to order.

After that, read the instructions and read the FAQ here.

It's really rather simple to do. Just a PITA to get everything out of the way.

KT

Re: Hurst Shifter
 

There is a write up (with pics) by Johnny "Phrogs" over on that "Other Forum Who Shall Not Be Named".
http://forums.*************.com/show....php?t=1063558
You will have to cut and paste and edit the link for it to work.
It's obvious what part is missing.

Good luck!

Tom

Re: Hurst Shifter
 

That is the write up I used and everything went great. Johnny also replied to my PMs with helpful hints.

Re: Hurst Shifter
 

I found the link. Thanks alot. This should help alot. I'll let you know how it goes this weekend.



:dancing

Re: Hurst Shifter
 

Chevetteforum right?

Re: Hurst Shifter
 

Yes, it was in the Forum under Archived links.

Re: Hurst Shifter
 

Contact
www.zfdoc.com

Re: Hurst Shifter
 

Thanks for the info about checking for bearings. Sure enough mine didn't come with any although the box said it did. Please let me know the Timken numbers

Re: Hurst Shifter
 

Double check your shifter again - There should be a small needle bearing cage on each side of the shifter body. I just got one from Jeg's - and the bearings are there. I can't see how they would be missing - They are press fit.:confused:

Don Yoakem
91-#267 Dark Red Met.