Oil Cooler Hose; male connector to housing
 

Damn these will not come off......anyone have any info on them?

Re: Oil Cooler Hose; male connector to housing
 

These dudes
http://i134.photobucket.com/albums/q...f/DSCN4547.jpg

Re: Oil Cooler Hose; male connector to housing
 

Lee, mine were on very tight as well. I just used a pipe on the end of my wrench. I don't think it's likely that you'd crack the housing while loosening them (only if overtightening, would that be a risk).

Re: Oil Cooler Hose; male connector to housing
 

Are they reverse threaded?, I actually was lifting the motor with a 3 ft bar.....nothing..anyone know what size these are?????

Re: Oil Cooler Hose; male connector to housing
 

No, not reverse threaded, standard lefty-loosey thread :). No idea what size the thread is, sorry. It is a tapered thread, but I don't know what size.

Re: Oil Cooler Hose; male connector to housing
 

1 1/4?

Re: Oil Cooler Hose; male connector to housing
 

well the wrench size is 1 1/8 so the thread must be smaller than that.

Re: Oil Cooler Hose; male connector to housing
 

All I remember is I bought 4 wrenches for the job 1 inch 1-1/8 and 1-1/4 and 1-1/2. I used three of them all lol

Re: Oil Cooler Hose; male connector to housing
 

They are a std MNPT, 3/4' I think, but would have to verify in the morning.

Why are you removing them?

http://jerrysgaskets.com/store2/root...roducts_id=272

Re: Oil Cooler Hose; male connector to housing
 

Was going to put them on the new motor, I did not have them on my spare oil housing

Did you get your surprise present Jerry?