Sleeve Thickness
 

I'm trying to verify the thickness at the top of a stock cylinder liner, can someone with a motor apart mic this for me? I checked my 368 liners and they are .075 thick so I think stock should be .125in.

Re: Sleeve Thickness
 

Not sure which dimension you mean, so I'll give you three of them. I took these measurements with a digital caliper on the stock liner that I removed from my '90 LT5.

Liner wall (outer to inner edge) is .295"

Liner wall at the flat is .245"

The ridge at the top of the liner (I think this is the dimension you want?) is .100"

Re: Sleeve Thickness
 

Thanks guys! The measurement that Cliff posted in the pic is the one I was curious about.