Clutch master cylinder line
Anyone know who has these?
|
Re: Clutch master cylinder line
Saw a stainless flex one, but don't know where it came from:dontknow:
|
Re: Clutch master cylinder line
Lee,i took mine to a place near me and rebuild my line for around $60.
Pete |
Re: Clutch master cylinder line
have you tried?
http://www.tld-corvette.com/products.asp?dept=905 they show them there also at Corvette America http://www.corvetteamerica.com/cf/di...ategoryid=X735 |
Re: Clutch master cylinder line
Quote:
Pete where did you have it done....better than $150 Thanks |
Re: Clutch master cylinder line
|
Re: Clutch master cylinder line
Anyone have the fitting sizes for this? Looking to have a line made.
|
Re: Clutch master cylinder line
Lee,
If you get the correct hose fittings, we can make them fairly easily. I made my fuel lines on the 84. |
Re: Clutch master cylinder line
Pegasus racing has pre made but only standard, with -3AN or -4 AN lines, need to know the flare fitting sizes to get a male adapter...also need to find meteric I assume.....you can get a premade line for about $28, plus cost of male fittings.
|
Re: Clutch master cylinder line
Well it appears the fitting is 12mm but I am not sure of the thread pitch went to autozone and True Value, all they had was a 12X1.25 and it would not go.
So either the male adapter is a M12 X1 or M12 X .8 Please let me know if anyone knows the size. |
Re: Clutch master cylinder line
If I use a Male 12 x 1.0mm Metric Convex Seat to 3AN Male connector then use a braided teflon brake hose, I assume this would work as a clutch line. The cost would be $16 for the fittings and $26 for the hose....does this sound correct? I am guessing I need about 30-32" of line.
|
Re: Clutch master cylinder line
After a long wait, got my line today...stainless steel and formed lines, same as OEM...very nice $85 plus $10 shipping.
|
All times are GMT -4. The time now is 01:51 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025