Re: WANTED: Cam position sensor for LT5
 

Reasonably sure the sensor I found will do the trick. Ordered a couple to make the necessary mods to and verify on my car. Should have a verdict by the weekend. Wish me luck!

Re: WANTED: Cam position sensor for LT5
 

Not just good luck, but GREAT LUCK!!

Re: WANTED: Cam position sensor and Dual mass flywheel for 1990 ZR1 LT5
 

May the spirit of Zora Duntov be with you.


Sent from my iPhone using ZR-1 Net Registry

Re: WANTED: Cam position sensor for LT5
 

I'm going to send you all of the information - this evening likely but no later than in the AM.

Re: WANTED: Cam position sensor for LT5
 

Lots of Luck be with you :thumbsup: :thumbsup:

And...Thank You WVZR-1 for all your technical Information :handshak::handshak:

Re: WANTED: Cam position sensor for LT5
 

Nice work Phil and Bob... hope this comes together.
H
:icon_sant

Re: WANTED: Cam position sensor for LT5
 

Pretty much all of the OEM terminals and connectors can be found at TERMINAL SUPPLY or MOUSER. I have a lot of the OEM connectors in a kit I’ve put it together,if somebody wants to post a picture of what your looking for I can confirm this.

Re: WANTED: Cam position sensor and Dual mass flywheel for 1990 ZR1 LT5
 

Here you go
https://uploads.tapatalk-cdn.com/201...b96955f253.jpg
https://uploads.tapatalk-cdn.com/201...a5398f6f84.jpg
https://uploads.tapatalk-cdn.com/201...8280e85600.jpg
https://uploads.tapatalk-cdn.com/201...ba6476211c.jpg


Sent from my iPhone using ZR-1 Net Registry

Re: WANTED: Cam position sensor for LT5
 

Looks the same as an O2 sensor connector.
H
:icon_sant

Re: WANTED: Cam position sensor for LT5
 

I can’t post pictures here of what I have but somebody send me an email and I’ll send a few pictures when I get off work. I’ve used these terminals when I put the Euro taillights in my car.