Re: Service (SIR) Supplemental inflatable Restraint
Quote:
|
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
|
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
|
Re: Service (SIR) Supplemental inflatable Restraint
I may have reversed what Killshot did. When my check engine light didn't work, I pulled the DIC and found a few bulbs had been removed, but they were sitting just beneath the DIC behind the bezel. I put the bulbs back in and now have these annoying lights. "low coolant level" and "INFL REST". I pulled the codes for the INFL REST and got 26, column circuit open. I may have tripped this one accidently when I changed out the steering wheel. I know the airbag is connected properly now, so I was going to clear the codes and see if it comes back on. Just don't know how to clear for a '91. the '90 procedures above did not work. May have to take bulb back out if I can't figure it out!
|
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
|
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
|
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
You and I are both relatively new Z owners. Our cars are going to cost us a few bucks, so it's up to us to decide whether we're going to spend the money making our cars more drivable, or spend the money making sure that every wire is the correct color and length. I've decided to let a 25-year old car just be a 25-year old car, and not try to make it perfect. Best of luck, and enjoy that beautiful gray car! GM should've painted them that color! Chris |
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
|
Re: Service (SIR) Supplemental inflatable Restraint
When dealing with the SIR system, you must fix the problem to clear the codes. As the system does a self check every time the the key is cycled to the run position. Otherwise you will never clear the INFL light.
With the 91, you can use flash code diagnostics, but certain codes can only be read and reset using a Tech1 with the SIR cartridge. Code 51 can not be cleared from the history at all. You are supposed to use the Tech1 to clear the codes, and the manual makes no reference to using the ground/unground method to clear the codes. If you correct the code 26 it should be changed to a "history" code and be removed from the "current" and the light will go out. Your code 26 was more than likely caused by your swap of the steering wheel. Hopefully you have not pinched or damaged the wire in the column coming from the coil to the inflator module. You may get lucky and find that you did not insert the connector correctly. |
Re: Service (SIR) Supplemental inflatable Restraint
Quote:
Check your local Yellow Pages for "Air Bag Service" companies or contact a couple local collision shops and ask who they use for service work. A code read and clear by an independent could be very inexpensive. Here's a link to an "information" TSB for '91 systems: http://www.corvetteactioncenter.com/...Restraint+(SIR) If indeed it's just a connection issue it may store to "History" but I believe there's no assurance that it will. OBD II is only emission related and drive-train related. There is no DIY for SIR regardless of the balance of the systems on the vehicle. |
All times are GMT -4. The time now is 10:30 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025