Re: Some Differences between 95's and 90'/91's
 

Valley Drain Port looks larger on 95' and goes from Valley into Bell Housing in front of Flywheel and then out with a large port in the Bell Housing Lower Cover plate (shown in photo looking upward in front of Bell Housing Lower Cover Plate and behind Rear of Oil Pan). No tube extends down as the Drain Port appears too large for a tube.

I actually applied engine degreaser and pressure washed the valley and the Larger Drain Port functions very well. I think if the Valley Drain Port on the 95' is not clogged with leaves that one could actually pressure wash the engine with no issues. I will add a photo of the Valley in a moment.

Valley with New Crankcase Cover Gasket installed
http://i287.photobucket.com/albums/l...17f93c2e34.jpg

Re: Some Differences between 95's and 90'/91's
 

You forgot the door storage pods :) 94-96

Re: Some Differences between 95's and 90'/91's
 

Is the hatch release backside of the passenger door still there? No Tire changing light either, Down in one window was on the 94 and up as well

Re: Some Differences between 95's and 90'/91's
 

No Hatch release on passenger door but does have Hatch release on Key Fob.

Re: Some Differences between 95's and 90'/91's
 

I believe 94s and 95s have softer springs but firmer shocks. 94s and 95s are raised a bit more than early cars to keep softer springs from causing nose scrape. I thinks this is achieved by extra rubber pads on the underside, outer edges of the front spring.

Re: Some Differences between 95's and 90'/91's
 

I dont recall an EGR on the 90. I'll look again....

Re: Some Differences between 95's and 90'/91's
 

No EGR until 93 (I think...). 94 and 95s have EGR.

Re: Some Differences between 95's and 90'/91's
 

Windshield

Re: Some Differences between 95's and 90'/91's
 

Windshield wiper to blade trunnion (different blades required)
Shocks
Shock gears
ASR & associated "stuff"
Master Cylinder
ABS (95 LT1 was upgraded & some say LT5 was too--can't remember)
Rear door jam "locker"--silver alignment pin
Rear storage compartments
Top wrench
No top bumpers (on inside frame) on 95s
Hood emblems & associated alignment holes
Selectable data on speedo LED

Re: Some Differences between 95's and 90'/91's
 

As Phil noted, go with a Hurst and eliminate the lift ring. I did that on my '93 and there is plenty of spring loading to keep you from putting it in reverse instead of fifth or sixth. Never had a problem and loved not having the lift ring. --Bob