ZR-1 Net Registry Forums
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

ZR-1 Net Registry Forums (http://zr1.net/forum/index.php)
-   C4 ZR-1 Technical Postings (http://zr1.net/forum/forumdisplay.php?f=9)
-   -   What are these M10 holes for? (http://zr1.net/forum/showthread.php?t=25526)

Fully Vetted 08-25-2015 04:31 PM
Re: What are these M10 holes for?
 
You'll need to remove the rear wheel so a jack and jackstand is needed but honestly you're not even under the car. If it wasn't for needing to drill that one hole (which is why you have to remove the wheel) you could almost do it with it on the ground.

Kevin 08-25-2015 05:13 PM
Re: What are these M10 holes for?
 
Quote:
Originally Posted by Fully Vetted (Post 231328)
You'll need to remove the rear wheel so a jack and jackstand is needed but honestly you're not even under the car. If it wasn't for needing to drill that one hole (which is why you have to remove the wheel) you could almost do it with it on the ground.
the prototypes didn't have the hole drilled, I was considering not doing it. I've had these things sitting in my garage for a year tomorrow. Bought them at carlise last year. Wife's banned me from buying more stuff till I install these...I need to get on it

BlackZR1 08-25-2015 08:22 PM
Re: What are these M10 holes for?
 
Quote:
Originally Posted by Kevin (Post 231280)
If you were looking to get a frame stiffener I'd go with https://www.vette2vette.com/?q=produ...r-bar-system-5

I have one in the garage, just need a lift to instal it
That's a nice kit Kevin. Looks well made. A bit pricey though.
Description says "does not require any body modifications to install. The system bolts to existing mounting holes with the supplied hardware"

Roger

Fully Vetted 08-25-2015 10:40 PM
Re: What are these M10 holes for?
 
You're right. My bad. I thought I remembered having to drill a hole. Actually it's a bracket you have to replace with the supplied bracket. Again, the only reason for having to take off the wheel is to gain access to that bracket. Still, it's a piece of cake mod.

BlackZR1 09-06-2015 09:24 PM
Re: What are these M10 holes for?
 
1 Attachment(s)
Quote:
Originally Posted by RussMcB (Post 231305)
That's a clever idea, Roger.

I've heard of something similar, from Miata racers. They buy hockey pucks on ebay and bolt them to the frame welds for jacking points.
Simple project is complete. Easy target for jack and large surface for jack stands. Avoids contact with fuel lines.

Roger


All times are GMT -4. The time now is 08:33 PM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025