Re: WTB Working ECM
 

I honestly don't want to sell it, I know not what you wanted to hear, I do want to get it fixed..

Re: WTB Working ECM
 

Check Jerry of Jerry's Gaskets. I exchanged my old ECM for a rebuilt one last year.

Re: WTB Working ECM
 

Do you need it because your car is not running? Or, Do you need it as a spare?

Re: WTB Working ECM
 

Car is running but am getting a knock sensor issue code 43 replaced the sensor tested the run between the sensor and the ecm all are good ECM i think is the only thing left to replace.

Re: WTB Working ECM
 

what about trying a different memcal. I seem to recall it has the ESC (knock) control on it..

Re: WTB Working ECM
 

I'm running Marc's chip wont that by pass the factory chip?

Re: WTB Working ECM
 

Depends.

Did you remove your memcal and replace it? or do you have a adapter board in the ECM?

if you replaced it.. swap in your factory chip and see if the code is still there.. if so then ECM, if not, then I suspect the little PCB on the MEMCAL

Re: WTB Working ECM
 

I have the adapter board "piggy back"

Re: WTB Working ECM
 

okay.. check to be sure the MEMCAL is on correct and tight..

IF so get another MEMCAL to verify that is not the issue

Re: WTB Working ECM
 

I will look for a new memcal its on right I have check it before thanks for the tip.