Re: Accessory Console Wiring
 

Well crap!!!!! You sure the unit is not internally fused. Also try this dom un plug it and plug it back in. It may reset. I know longshot but to test cost nothing

Re: Accessory Console Wiring
 

Assume you checked the power by using ground associated with cigar lighter and accessory plug. In other words you did not use a different ground?

Just making sure the grounds are complete with each of those circuits (cigar lighter and accessory plug).

Ohm any and all grounds back to negative terminal of battery.

Re: Accessory Console Wiring
 

Actually I did try that yesterday. WB display went dark and then motor would start and die. I have my MAP sensor connected to WB display. When I disconnected WB interface, motor ran. Reconnected, it died. This happened once before. Replaced module and voila. I'll check to see if it has an internal fuse but I doubt it.

Re: Accessory Console Wiring
 

Must have over worked the WB. I have a new LC1 I should probably sell

Re: Accessory Console Wiring
 

WB Controller not internally fused.