Question about removing Bose and installing Pioneer

[secondchance]

Originally Posted by max76

I secondchance...i have all the bose system (head unit and speaker) but i insallet 4 little amp in every speaker box (if i remember correctly 25watt), they work good with the original cable, but when i turn on there is a popping as you say and also i hear the alternator whine...and when you run the car is very very noise...how i can erase this noise? Thanks in advance

Do you hear these noises in all 4 speakers? Most likely not. If so, replace the amps on the side where you hear the popping and/or whine. Factory system should run noise free as was installed.

[max76]

Originally Posted by secondchance

Do you hear these noises in all 4 speakers? Most likely not. If so, replace the amps on the side where you hear the popping and/or whine. Factory system should run noise free as was installed.

Yes, in all 4 speakers...i try to change one amp but the result is the same...i have all the bose system except the 4 amps...but there is a lot of noise...

[secondchance]

Originally Posted by max76

Yes, in all 4 speakers...i try to change one amp but the result is the same...i have all the bose system except the 4 amps...but there is a lot of noise...

When you say you installed 4 amps, you mean 4 non Bose amps? If so, that won't work. Bse is 2 ohm system and typical aftermarket car amps are 4 ohm system.
If you want amps that work and more wattage, look for 97 to 00 Eldorado Bose amps. These Eldo Bose amps are same width and height but a little taller. C4 Bose amps are 50W and Eldo version is 100W.
Rear will fit with no mod but fronts, cover will have to be built up.
Typically Eldo Bose amps are sold as speaker assembly. So, you will have to buy the entire speaker/enclosure and remove the amp for our application.

https://www.zr1.net/forum/showthread.php?t=26010

While at it, mix Elmer's glue 50/50 with water and apply 3 coats (dry thoroughly between the coats) on speaker cones. This will stiffen the speaker cones and improve the sound.

[max76]

Originally Posted by secondchance

When you say you installed 4 amps, you mean 4 non Bose amps? If so, that won't work. Bse is 2 ohm system and typical aftermarket car amps are 4 ohm system.
If you want amps that work and more wattage, look for 97 to 00 Eldorado Bose amps. These Eldo Bose amps are same width and height but a little taller. C4 Bose amps are 50W and Eldo version is 100W.
Rear will fit with no mod but fronts, cover will have to be built up.
Typically Eldo Bose amps are sold as speaker assembly. So, you will have to buy the entire speaker/enclosure and remove the amp for our application.

https://www.zr1.net/forum/showthread.php?t=26010

While at it, mix Elmer's glue 50/50 with water and apply 3 coats (dry thoroughly between the coats) on speaker cones. This will stiffen the speaker cones and improve the sound.

I installed 4 amps (bought on aliexpress) very very cheap...(i'm not an electronic)...the system work, the only problem is the noise....

[secondchance]

Originally Posted by max76

I installed 4 amps (bought on aliexpress) very very cheap...(i'm not an electronic)...the system work, the only problem is the noise....

Incompatibility between 4 ohm amps trying to work with 2 ohm Bose system.