ZR-1 Net Registry Forums - View Single Post

Jcsws6 · 01-23-2022

I recently installed a set of Maximizers on one of my cars and really like them. The quality was better than the last set of SW I bought. As Mr. Blue said, you need to dimple for the steering shaft a bit. You also need to make the little bracket to offset the dipstick tub. I plan to install a few more sets of them in the future.

As a side note, the OBX catback isn't bad either. You need to replace all the clamps, but the build quality is good.

01-23-2022	#10
Jcsws6 Join Date: May 2021 Location: Freeburg IL Posts: 44	Re: Headers I recently installed a set of Maximizers on one of my cars and really like them. The quality was better than the last set of SW I bought. As Mr. Blue said, you need to dimple for the steering shaft a bit. You also need to make the little bracket to offset the dipstick tub. I plan to install a few more sets of them in the future. As a side note, the OBX catback isn't bad either. You need to replace all the clamps, but the build quality is good.