ZR-1 Net Registry Forums - View Single Post - Sway bar link bushing install, frustrated in FLl

32valvZ · 01-29-2019

I have almost all the rear done... I just need to install the thrust arms I think they are... the big ones on the bottom that go from the knuckle to the center section.... bushings are all in, just need to swap arms...

I been skeered to tackle the fronts... I have all the ES bushings sitting on the bench too.... I have a 12 ton press that should work... i hope... I wanted this done by the spring... I hope I can muster up the time & courage to get it done...

01-29-2019	#10
32valvZ Join Date: Nov 2007 Location: Sunshine State Posts: 1,071	Re: Sway bar link bushing install, frustrated in FLl I have almost all the rear done... I just need to install the thrust arms I think they are... the big ones on the bottom that go from the knuckle to the center section.... bushings are all in, just need to swap arms... I been skeered to tackle the fronts... I have all the ES bushings sitting on the bench too.... I have a 12 ton press that should work... i hope... I wanted this done by the spring... I hope I can muster up the time & courage to get it done... __________________ [B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B]