Quote:
Originally Posted by Roadster
....
Do you carry the part where the hoses connect into??? the bottom hole in the connector is the "curly" line connected to the LSF of the plenum.
|
No I do not have it. I can tell you that the single zip tie around the whole rubber connector will do more to create vacuum leaks than to prevent.
EDIT, text added: Zip ties can be used, but work much better if you slice out enough rubber
between the pipe holes to use 2 zip-ties, 1 around each pipe. If you do that, it means you will connect/disconnect the pipe at the other end during plenum pulls, where the small spring clamp is.
I haven't personally done what I'm about to suggest, but have sure thought about it while having difficulty with that pipe & the rubber connector. Why not cut off a short section of the plastic pipe & glue it into the connector? Then get a section of vacuum hose long enough to eliminate the looped section of plastic pipe so it's not so hard to install.
__________________
Jerry Downey
JERRYS LT5 GASKETS & PARTS
http://www.jerrysgaskets.com
1994
ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc.
2016 Black-Red, 3LT-Z51 Auto 8-speed.