Quote:
Originally Posted by Mystic ZR-1
Cam covers going to the PCer next week.
How do you remove the secondary timing chain
guide strips?
Any special kind of wire to retain the new foam
filters during reassembly?
Thanks!
OBTW: not a single scratch in the guide strips!
|
Cam Cover Chain Guides clip onto a Chain Guide Holder held on by two small screws.
Cam Cover Chain Guides
I switched from Scotch Brite to Marc Haibeck's new Cam Cover Vent filter material Cam Cover Filters
I think any kind of wire the size of a regular paper clip would work fine (bend straight a paper clip and cut so about 3/8 inch of the Paper Clip sticks out each side of the Cam Cover Filter Housing). Insert the straightened Paper Clip after the Cam Cover Filters are installed. Then.....bend each end of the wire sticking out of the Cam Cover Filter aluminum sides about 3/8 inch 90 deg so they will not drift out of place.
Be sure you do NOT loose those two dowel Pins aligning the Cam Covers with the Heads (one each end of the Head)
See Cam Cover Chain Guides, Filters, and A136
Now you can delete your redundant Post #20 