No Spark on Cyl 2 &3
Team,
I have completed an under the plenum service. All new D545 Ac Delco coils, and cyl 2 and 3 do not fire. I took it back apart, and the coil tests good on the primary, and secondary, and the INJ1 fuse is good. What else besides the coil can cause this? Thanks in advance! |
Re: No Spark on Cyl 2 &3
Just guessing, but did you put the ignition module plug back in place carefully so that no contacts were bent?
|
Re: No Spark on Cyl 2 &3
Quote:
|
Re: No Spark on Cyl 2 &3
Recently I installed a set of Standard Motor Products blue streak coils. Had some ignition difficulties soon after. Upon checking all plug wires with a spark gap tester, coil 2,3 was very weak. Took plenum off again, put in a known good used coil, problem was solved. Do you know what the word NEW means? Never Ever Worked. It?s been preached here before just because you put in new parts doesn?t mean they?re good parts. PS the weak coil tested fine also.
|
Re: No Spark on Cyl 2 &3
Switched coil position, runs like a rocketship again, no issues??..
|
Re: No Spark on Cyl 2 &3
Quote:
|
Re: No Spark on Cyl 2 &3
Quote:
Whenever possible, the best (only???) way to determine if a part is failing, is to MEASURE the bitch! Measure its performance before (to confirm an issue) & after (to confirm it is functioning properly). Where ppl get into trouble is making assumptions: assuming a part has failed, and replacing it w/o verifying its performance by direct measurement (if possible). Replacing parts 'until the problem goes away' is not only expensive, but w/o verifying (testing) one leave himself open to multiple failures by introducing a new twist, that - Never Ever Worked item - just adding to the complexity of the initial issue. Good post. Ya beat me toit! |
Re: No Spark on Cyl 2 &3
I measured all coils when I took at back apart, and they all tested good, primary and secondary.
So, the dark green wire that comes out of the DIS plug, is that the long rectangular plug that plugs into the DIS, next to the crank position sensor? |
Re: No Spark on Cyl 2 &3
Quote:
|
Re: No Spark on Cyl 2 &3
Quote:
|
All times are GMT -4. The time now is 12:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020