WTB Passenger Side Rear Bumper Molding

[rebelz]

This is for my 1992 ZR-1. Very minor Bumper Thumper, but I want to replace the damaged part if I can, not try to have it repaired.

Rich Ballou

[4DSZR1]

Are they side specific?? Do you know?

Good Luck!!

Rick

[rebelz]

In the ZR-1 parts PDF I have it lists LH 10174848 & RH 10174849, so I have to assume you can't just flip one over 180° to make it fit the other side. I don't know that for a fact though. I think if I was designing those that is the way I would do it. On all the outer body molding just flip it to fit the other side.

Rich