93 ZR-1 New and Used Parts for sale

[Jerry#397]

Recently sold my Z and decided to give the forum/net folks first choice prior to the Bay. All parts are PLUS shipping. Cashiers check or money order, personal checks must clear the bank prior to shipping. PM me with your e-mail address and phone number. PIC's availalbe on request.
Thanks,
Jerry

93 ZR-1 New/Used Parts and Accessories

NEW

- LT-5 Kurt White bearing kit (rods and mains) - $400.00

ALL PARTS, NEW AND USED INCLUDING THE A-MOLDS, HAVE BEEN SOLD WITH THE EXCEPTION OF THE BEARING KIT. THANKS TO ALL.

[limey]

Recently sold my Z and decided to give the forum/net folks first choice prior to the Bay. All parts are PLUS shipping. Cashiers check or money order, personal checks must clear the bank prior to shipping. PM me with your e-mail address and phone number. PIC's availalbe on request.
Thanks,
Jerry

93 ZR-1 New/Used Parts and Accessories

NEW
- LT-5 Kurt White bearing kit (rods and mains) - $400.00
- Clutch Master Cylinder (in box) - SOLD
- Clutch Hydraulic Slave Cylinder (in box) - SOLD
- “Clutch Kit” (in box), Valeo Pressure Plate (ZR-1 correct 17mm thick plate), Throw out Bearing (94-95, has Teflon sleeve), pilot bearing and alignment tool. NOTE: disc damaged in shipment. Pilot bearing is needle bearing type. - $100.00 (I'll take that)
- Complete dual fuel pump assembly (both pumps) including sending unit - $265.00
- 2 Secondary Fuel Injector Actuators - $50.00 (I'll take them both)
- AC Delco Spark Plug Wires (red, they don’t have cyl. Numbers) in box - $75.00
- Black Rubber complete hose kit (purchased from Corvette Central, in box) - $50.00 (I'll take that set, if it's all 6 coolant hoses)
- Brake Pad and Anti rattle clips (2) (in boxes) - $20.00
- Plenum removal gasket kit (in box and bags) - $50.00
- Delco Remy Starter (in box) - $150.00 *
- AC Delco Water Pump and gasket (in box) - $320.00 *
• Starter and Water Pump as a combination $400.00
- O2 AR extension cord (never used, came with Jeal Hdr Set, in bag) - $20.00
- 90-92 LT-5 Jeal Header collection hdr to flange adaptor (right side) - $20.00
- Drivers side vent fender (the one you have to remove to get the battery out); white, in box - $50.00
- Front License Plate Filler: white, in box - $25.00
- Bray Krause Sub Belt mounting Bar - $25.00

Accessories

- Black Dash Mat (never used) - $25.00
- 1 can of “Lingenfelter” gray (LT5) paint - $10.00 (I'll take that)
- Memory Saver Power cord 9 volt (plugs into the cig. Lighter prior to disconnecting the battery (bought from Mid America) never used - $10.00
- 92-95 Full Power bypass switch? (bought from Mid America) - $5.00
- Peel off headlight covers - Free

USED

- Complete set (front and rear) OEM “A-mold” (5 spoke) polished aluminum wheels (no curb rash); wheels were polished in 1996, removed from ZR-1 at 65,000 miles and replaced with after market wheels in 2002. Included are the OEM pressure sending units - $1000.00
- 93 drive shaft, u joints and spline - $50.00
- Chrome Radiator Inlet Pipe (yes the hard to find one) (like new) - $100.00( is this the coolant croosover pipe, if so, i'll take it)
- Radiator Hose Kit (removed from car 2 yrs ago, replaced with Samco hoses. These hoses are in good shape with clamps) - $25.00
- Wiper Arm Assemblies - $25.00
- Open Air Filter Housing (painted silver) (include 1 bolt) - $20.00
- Cooling Fan Motor - $25.00
- 15 psig radiator cap - $5.00
- Halogen “sealed beam” headlights (2) - $10.00
- 2 “blue halogen head light bulbs” - $20.00
- 2 Bosch #13077 O2 AR’s (in perfect condition when removed from exhaust system) - $25.00
- Serpentine belt tensioner and pulley (tensioner in good shape, I would replace the pulley prior to installation if I were buyer) - $25.00
- Stock Throttle Body Coolant Cover (LT-5 silver) - $10.00
- Passenger side window switch and bezel - $20.00
- Drivers side door mirror bezel with switch - $20.00
- Center console “seat, ride control (and switch) bezel” - $40.00
- Throttle body to air filter “accordion hose” (good shape) - $25.00
- Stock Front Calipers (pair) - $25.00
- All four (4) (front and back) rotors, have been miked and turned/trued 5/28/09 - $100.00
- Secondary Vaccum pump (don’t know if it’s good) - $20.00
- Stock 26mm front way bar - $35.00 *
- Stock 24mm rear sway bar - $35.00 *
- VBP 32mm solid front sway bar - $75.00 *
• Buy all 3 sway bars for $100.00
- Windshield (one small rock chip upper drivers side, minimum. delam.) - $50.00 (you pick it up, it's in a Kurt White Crate, I live in the bay area of Northern Calif.)

Let me know on the above requests.

[GOLDCYLON]

PM sent as well

Ill take the Brey Krause sub bar
The white side panel
The 02 exdender for the Jeal headers
The Flange for the Jeal headers
Driver side mirror bezel with switches does this include the power window switches?

)

- O2 AR extension cord (never used, came with Jeal Hdr Set, in bag) - $20.00

- 90-92 LT-5 Jeal Header collection hdr to flange adaptor (right side) - $20.00

- Drivers side vent fender (the one you have to remove to get the battery out); white, in box - $50.00

- Bray Krause Sub Belt mounting Bar - $25.00

- Passenger side window switch and bezel - $20.00

[RICKYRJ1]

I would like the can of LPE engine paint. PM me mailing info I will send out MO :handshak:

[Sgreg]

PM sent last night. Let me know please.

[scholtmj]

Sent you a PM.

[salvatore1]

Recently sold my Z and decided to give the forum/net folks first choice prior to the Bay. All parts are PLUS shipping. Cashiers check or money order, personal checks must clear the bank prior to shipping. PM me with your e-mail address and phone number. PIC's availalbe on request.
Thanks,
Jerry

93 ZR-1 New/Used Parts and Accessories

NEW
- LT-5 Kurt White bearing kit (rods and mains) - $400.00
- Clutch Master Cylinder (in box) - SOLD
- Clutch Hydraulic Slave Cylinder (in box) - SOLD
- “Clutch Kit” (in box), Valeo Pressure Plate (ZR-1 correct 17mm thick plate), Throw out Bearing (94-95, has Teflon sleeve), pilot bearing and alignment tool. NOTE: disc damaged in shipment. Pilot bearing is needle bearing type. - $100.00
- Complete dual fuel pump assembly (both pumps) including sending unit - $265.00
- 2 Secondary Fuel Injector Actuators - $50.00
- AC Delco Spark Plug Wires (red, they don’t have cyl. Numbers) in box - $75.00
- Black Rubber complete hose kit (purchased from Corvette Central, in box) - $50.00
- Brake Pad and Anti rattle clips (2) (in boxes) - $20.00
- Plenum removal gasket kit (in box and bags) - $50.00
- Delco Remy Starter (in box) - $150.00 *
- AC Delco Water Pump and gasket (in box) - $320.00 *
• Starter and Water Pump as a combination $400.00
- O2 AR extension cord (never used, came with Jeal Hdr Set, in bag) - $20.00
- 90-92 LT-5 Jeal Header collection hdr to flange adaptor (right side) - $20.00
- Drivers side vent fender (the one you have to remove to get the battery out); white, in box - $50.00
- Front License Plate Filler: white, in box - $25.00
- Bray Krause Sub Belt mounting Bar - $25.00

Accessories

- Black Dash Mat (never used) - $25.00
- 1 can of “Lingenfelter” gray (LT5) paint - $10.00
- Memory Saver Power cord 9 volt (plugs into the cig. Lighter prior to disconnecting the battery (bought from Mid America) never used - $10.00
- 92-95 Full Power bypass switch? (bought from Mid America) - $5.00
- Peel off headlight covers - Free

USED

- Complete set (front and rear) OEM “A-mold” (5 spoke) polished aluminum wheels (no curb rash); wheels were polished in 1996, removed from ZR-1 at 65,000 miles and replaced with after market wheels in 2002. Included are the OEM pressure sending units - $1000.00
- 93 drive shaft, u joints and spline - $50.00
- Chrome Radiator Inlet Pipe (yes the hard to find one) (like new) - $100.00
- Radiator Hose Kit (removed from car 2 yrs ago, replaced with Samco hoses. These hoses are in good shape with clamps) - $25.00
- Wiper Arm Assemblies - $25.00
- Open Air Filter Housing (painted silver) (include 1 bolt) - $20.00
- Cooling Fan Motor - $25.00
- 15 psig radiator cap - $5.00
- Halogen “sealed beam” headlights (2) - $10.00
- 2 “blue halogen head light bulbs” - $20.00
- 2 Bosch #13077 O2 AR’s (in perfect condition when removed from exhaust system) - $25.00
- Serpentine belt tensioner and pulley (tensioner in good shape, I would replace the pulley prior to installation if I were buyer) - $25.00
- Stock Throttle Body Coolant Cover (LT-5 silver) - $10.00
- Passenger side window switch and bezel - $20.00
- Drivers side door mirror bezel with switch - $20.00
- Center console “seat, ride control (and switch) bezel” - $40.00
- Throttle body to air filter “accordion hose” (good shape) - $25.00
- Stock Front Calipers (pair) - $25.00
- All four (4) (front and back) rotors, have been miked and turned/trued 5/28/09 - $100.00
- Secondary Vaccum pump (don’t know if it’s good) - $20.00
- Stock 26mm front way bar - $35.00 *
- Stock 24mm rear sway bar - $35.00 *
- VBP 32mm solid front sway bar - $75.00 *
• Buy all 3 sway bars for $100.00
- Windshield (one small rock chip upper drivers side, minimum. delam.) - $50.00 (you pick it up, it's in a Kurt White Crate, I live in the bay area of Northern Calif.)


Jerry - I need the engine cooling fan for drivers side for a 91 Z. Is the one you have in good working order?

[White Bullet]

Jerry,
I would like the serpentine belt tensioner and pulley. PM sent will pay with MO. Thanks.

[Jerry#397]

SALVATORY,

Send me a PM with your e-mail address. I believe both fan motors are the same?

Thanks,
Jerry

[GOLDCYLON]

Jerry responded to your email and sent you a pm as well

[GOLDCYLON]

Gerry ok looked at everything I will take

1. Sub bar
2. O2 Extender jeal
3. Pipe Jeal
4. White Side Panel
5. White License plate filler

The switches are the wrong color as mine are all grey in the 91 and my lettering is orange. I already have a complete FX-3 switch set with the harness already so I will pass on all the switches but add the license plate filler sound good? Daryll

[tomtom72]

Is a PM required or may I post here to inquire about the OEM cooling hoses and the OEM clamps?

Thank you Jerry and I apologize if you wanted me to PM instead.:redface:

:cheers:
Tom

Do I understand that it's just the upper & lower radiator hoses & their clamps???

[Hammer]

Thanks Jerry. Great parts.

[Jerry#397]

TomTom,

E-mail @ gschub1469@aol.com or use the PM. The hoses, both new and used have been sold. Need a stock radaitor that was removed from my car about 3 yrs ago, it was in good condition at that time and has been in box on the shelf?

Jerry

[GOLDCYLON]

Thanks Jerry nice parts and great packing! GC :cheers:

[GOLDCYLON]

Jerry PM sent of the actuators

[JAX S50]

[quote=GOLDCYLON;64002]Jerry PM sent of the actuators[/quot

I would like to be next in line for the actuators if something should fall through, provided they will work on my 1990.....thanks Jack

[Jerry#397]

Jack,

Your on the list. Have sent pics to two other folks, waiting on reply, will let you know tomorrow.

Thanks,
Jerry

[GOLDCYLON]

Jerry PM and email sent thanks. Daryll

[scholtmj]

Jerry,
Parts came in the mail yesterday. Thank you very much! Great seller :worship:

[Jerry#397]

Matt, thanks and recieved the payment.

Jerry

[White Bullet]

Part received in great condition. Thanks.

[Jerry#397]

David,

Thanks for the feedback.

Jerry

[GOLDCYLON]

Jerry Payment sent thanks