PDA

View Full Version : New Custom Pistons in my LT5

LGAFF
10-30-2008, 10:12 PM
With all the difficulty and headache I have had so far, I thought I would forge my own custom pistons. I was able to do this with the help of a company that originated in St. Louis but is now German owned.

These pistons are heavier than the "Light" versions but I like them, and am working on the third piston as we speak. I hope to have at least 8 done by the end of the night.

They said that these would produce some serious cyldesdales!

http://i134.photobucket.com/albums/q115/lgaff/DSCN0139.jpg

LGAFF
92 ZR1
#234
jonszr1
10-30-2008, 11:04 PM
with the tops down you would have good oil retention inside the new pistons :mrgreen:
LGAFF
10-30-2008, 11:10 PM
12ozs for pistons, I an polishing off a few 20ozs for liners.

:cheers:
LGAFF
92 ZR1
#234
FU
10-31-2008, 05:20 AM
Ultralight's !!
tomtom72
10-31-2008, 06:46 AM
Now those are some "custom" slugs......look to be that new light weight rolled aluminium technology.....brilliant! I'll bet it will run on bio-fuel too!=D>
blackjack
10-31-2008, 08:48 AM
i have some experience with that company's products...you should see the power they give in a v12 !!
bj
LGAFF
10-31-2008, 09:17 AM
I asked the guy is he though they would help be pick up a few tenths, he said yes.....in BAC.

LGAFF
92 ZR1
#234
jonszr1
10-31-2008, 11:54 AM
custom dish piston tops . could be for a big boost turbo aka beer fart :cheers:. i wonder if the waste gate will melt under all that boost
flyin ryan
11-01-2008, 12:15 AM
unfortunatly those "cans" are only good for bench racing...too bad:dontknow:
jonszr1
11-01-2008, 11:52 AM
ah yes , and a little fun satire ,brings a smile to ones face