PDA

View Full Version : no back up lights?

detch
10-19-2008, 10:17 PM
I just purchased a 95 and the back up lights don't work, the bulbs and fuse are good, the switch at the transmission has been replaced but still no BU lights. The formal owner had a B&M shifter installed, any ideas on what could cause this or what to do next?

thanks:icon_scra
GOLDCYLON
10-20-2008, 12:06 AM
Hmm you sure the switch is good?
flyin ryan
10-20-2008, 12:59 AM
Hmm you sure the switch is good?ditto:iamwithst
evl_twn
10-20-2008, 03:53 PM
How hard are the switches to replace? :confused:
Chris_32212
10-20-2008, 04:02 PM
sounds like there is an "open" in the circuit. that could be a break in the wire somewhere or it could be a bad switch. if you have a multimeter and know how to use it, that would be the best place to start.

Chris
Pete
10-20-2008, 04:12 PM
Did you make sure the little slug was still in the hole when you replaced the reverse switch.

Pete
Jeffvette
10-20-2008, 04:37 PM
Did you make sure the little slug was still in the hole when you replaced the reverse switch.

Pete

That would be my guess.
flyin ryan
10-20-2008, 10:59 PM
How hard are the switches to replace? :confused:no way to put it other than...a real B*T*H! i posted pictures a while back of an off-set 22mm wrench i carved up for the job.
detch
10-22-2008, 07:22 PM
what is the little slug? and where would i get one? i did not change the switch so I don't know if it was replaced.