B&B exhaust install ??

[32valvZ]

My new set-up should be here tomorrow according to UPS :mrgreen: .......I noticed that there are no fastening points for the spring hangers on the B&B like on the stock set-up. Does it just use the cat outlets and the 2 muffler hangers?

[Zr1 Destroyer]

You should have the two hangers on the rear aswell as the tail of the tranny orrrr are you talking about something else?

[Zr1 Destroyer]

My new set-up should be here tomorrow according to UPS :mrgreen: .......I noticed that there are no fastening points for the spring hangers on the B&B like on the stock set-up. Does it just use the cat outlets and the 2 muffler hangers?Ahhhh...I re-read your post...lol...just the two cat outlets and the factory hangers.....just like factory.

[32valvZ]

So, I'm eliminating any of the spring type hangers?
Only using the two at the mufflers other than where the two pipes in front of the resonator go to the cats...yes?
Thanks, John

[Zr1 Destroyer]

So, I'm eliminating any of the spring type hangers?
Only using the two at the mufflers other than where the two pipes in front of the resonator go to the cats...yes?
Thanks, JohnThe spring hangers stay. Other then that it just goes right where the factory deals went.

[32valvZ]

Ok, I looked at the pics again...I see one of the tabs, so there must be 3 more.....I hope!:???: