PDA

View Full Version : Clutch cap stuck


rogerzr1
01-19-2008, 05:34 PM
I was going to add some fluid to the clutch, got the ECM out of the way, but can't budge the cap. I am scared to force it too bad as it looks like I could break the whole thing. Any tips?

Never mind. I went ahead and forced it. It came off ok. Sorry.

lbszr
01-20-2008, 05:04 AM
I was going to add some fluid to the clutch, got the ECM out of the way, but can't budge the cap. I am scared to force it too bad as it looks like I could break the whole thing. Any tips?

Never mind. I went ahead and forced it. It came off ok. Sorry.


Sounds like you did the right thing, "If it jams, force it. If it breaks, it needed replacing anyway"; Flugg's Rule ...:cheers:

RedSled
01-20-2008, 12:20 PM
I was about to do the same thing today. I haven't looked it up, but does it take much to get the ECM out of the way?

bradslt5
01-20-2008, 01:46 PM
no its easy . just take off the 2 10mm bolts spread the plastic holder a little with your fingers. and its loose. hope this helps

RedSled
01-20-2008, 02:25 PM
Will give it a go. It's just nice to have advice even on the easy stuff when you haven't done it before to keep from going "oh sh*t" after you crack something off. The manual is always so helpful - it goes into the great detail of saying something like "remove ECM." Thanks!

RedSled
03-02-2008, 04:51 PM
OK. ECM out of the way and yeah...that darn cap is stuck. Does it twist off or just pull up. It is stuck on there hard. Thanks!

Jeffvette
03-02-2008, 08:25 PM
Sometimes they take a little bit of force. They are pretty tough.

QB93Z
03-02-2008, 10:41 PM
You have to unscrew the cap. Some times it takes a little extra leverage since it is hard to get a good grip on the cap.
Jim

Jason 91
03-04-2008, 11:27 PM
I found that mine was real hard to get off. I thought I was going to break it to take it off.

Jason