Rear amber indicators.

[Ozruss90]

Can anyone steer me in the right direction on how to make the inner 2 lamps only, work as the indicators. I have the amber lenses. It?s an state requirement here in Australia for registration that the rear indicator be amber. Thanks in advance.

[dredgeguy]

Not sure if they have a kit for what you are looking for but worth a try:
https://www.webelectricproducts.com/
Good luck and let us know.

[G8nightman]

You should be able to modify the harness. You can use a test light to figure out what wire does what and then just cut the ones you don't need to get the configuration you want

[-=Jeff=-]

you will need to run an extra wire.. from the turn signal switch under the dash, or snag the brake light wire from the CHMSL.. I ran an new wire form the switch for my euro lamps, that new wire became the brake light and the existing wire became the turn signal.

[davids1978]

You will need to modify your tail lights, parkers and install side markers to get a VASS (as well as set belts etc). I have some PDF instructions but can't seem to post them here, send me a PM and I'll try to attach it to the reply.

The alternative is to have someone take care of all modifications, engineering & RWC - I can recommend someone in Melbourne if you want to go down this path (he did my 95 last year).

[Ozruss90]

You will need to modify your tail lights, parkers and install side markers to get a VASS (as well as set belts etc). I have some PDF instructions but can't seem to post them here, send me a PM and I'll try to attach it to the reply.

The alternative is to have someone take care of all modifications, engineering & RWC - I can recommend someone in Melbourne if you want to go down this path (he did my 95 last year).

Thanks David, PM sent.