PDA

View Full Version : Tensioner pulley

Wigert
05-18-2021, 04:58 PM
Hello

A while back I bought the following pulley from rock auto
ACDELCO38015Tensioner Pulley

But I now noticed that it does not have flanges when I stared replacing it. Would this be a bad replacement or should it be fine? Or should I press the bearing out and put it in the old pulley?

Thanks registry for your continues support!

Sent from my EVR-L29 using ZR-1 Net Registry mobile app (http://r.tapatalk.com/byo?rid=90383)
secondchance
05-18-2021, 05:31 PM
Below is my preference. Powder coated steel with flanges.

https://www.ebay.com/itm/New-Lower-Accessory-Drive-Belt-Idler-Tensioner-Pulley-Fits-Range-Rover-Ranger/272582709757?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Wigert
05-19-2021, 01:58 AM
Below is my preference. Powder coated steel with flanges.

https://www.ebay.com/itm/New-Lower-Accessory-Drive-Belt-Idler-Tensioner-Pulley-Fits-Range-Rover-Ranger/272582709757?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649Hey

I saw this option in another thread but it would take a while to get that one since I live in Sweden... That is why I asked if what I already have would work or not...

Sent from my EVR-L29 using ZR-1 Net Registry mobile app (http://r.tapatalk.com/byo?rid=90383)
secondchance
05-19-2021, 06:18 AM
What you have should work.
Wigert
05-19-2021, 08:18 AM
What you have should work.I will most likely order the one you suggested later but have to go through inspection soon and would like not to wait.

Thanks for the input!

Sent from my EVR-L29 using ZR-1 Net Registry mobile app (http://r.tapatalk.com/byo?rid=90383)