427" short block available

[tpepmeie]

I have taken on a new LT5 project and need to move this engine to a new home. I would prefer to sell as a complete assembled shortblock, but will consider separating.



2-bolt block, Closed deck ductile iron liners, 4.130" finished bore size
Bryant 4.000" stroke billet crankshaft.
Carrillo H-beam tapered rods
Ross Pistons & pins, Total seal rings



The shortblock was refreshed in 2016, and has only run-in hours on it since then. Never installed after refresh. This engine made over 700 bhp with good heads and cams.

Selling entire shortblock for $8500
or the Bryant 4" crankshaft for $4200
Reasonable offers considered. Please PM me if interested.

Todd

pepmeierengines@yahoo.com
(317) 503-3287
PepmeierEngineDevelopment

[tpepmeie]

There's been a few folks wanting pics and more info about this engine. You can see the entire freshening build from 2016 on my blog. Lots of pics and discussion of the build.
http://pepmeierenginedevelopment.blogspot.com/2016/

[CamP]

14.8:1 compression ratio?

[tpepmeie]

more like 14.5 when we finished the cc'ing of the heads.
I run E85 in it.

[CamP]

more like 14.5 when we finished the cc'ing of the heads.
I run E85 in it.

E85 is a lot cheaper than C12!

[Thomas ZR-1]

Email sent...

[tpepmeie]

Sold. Thanks


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)