LGAFF
02-28-2021, 10:27 PM
9 or 10 years ago I stumbled upon an advertisement in Classic Car magazine for someone that did rare and vintage cams and repairs, the business was called Cam Techniques. I called on the off chance I might be able to get some performance cams made. The owner answered, an older Gentleman, I told him I had an LT-5 engine and wondered if he could make cams. He laughed and said there's an engine I havent heard about for awhile. He went on to explain that he, Dave Generous, used to have his business in CT(now in FL), and that he did work for Callaway, including the infamous Sledgehammer.
He in fact had made LT-5 cams for Callaway and although the project had hit target for HP, etc... it was scraped due to EPA regulations that callaway would need to meet with the cam swap. I asked if he could make me a set and he did.... 236 .425 intake, and 222 .415 exhaust. Dave also put the 222.415 on the primary intake lobe. I put a set in my 90 and it made 441 RWHP. A few years later Dave told me he had cancer and was retiring. He asked if I wanted to buy the cam masters and I did, he also made a copy of the Sledgehammer cam for me... he also offered to make a few more sets of cams for me... but using the 236 .425 on both lobes. Years later I had someone else making the cams for me, and I sold the old pairs... and later found out that the primaries were not 236 on the old cams..... so that lead me to believe that maybe the more recent work I had done were also not 236 on both lobes(they had his notes and copies of old cams, along with the masters).
So recently I had another set of cams made and noticed that they weren't any different in measurement than the set of intakes in my basement. So I went about putting together a home made cam duration/lift device to measure them(patent pending) and it was interesting.. video is below.. I welcome feedback. One of my findings was that these cams are not measured at .05..( and yes the indicator is a Bic Pen Cartridge held on by painters tape)
https://youtu.be/kxLuGWYe4PA
He in fact had made LT-5 cams for Callaway and although the project had hit target for HP, etc... it was scraped due to EPA regulations that callaway would need to meet with the cam swap. I asked if he could make me a set and he did.... 236 .425 intake, and 222 .415 exhaust. Dave also put the 222.415 on the primary intake lobe. I put a set in my 90 and it made 441 RWHP. A few years later Dave told me he had cancer and was retiring. He asked if I wanted to buy the cam masters and I did, he also made a copy of the Sledgehammer cam for me... he also offered to make a few more sets of cams for me... but using the 236 .425 on both lobes. Years later I had someone else making the cams for me, and I sold the old pairs... and later found out that the primaries were not 236 on the old cams..... so that lead me to believe that maybe the more recent work I had done were also not 236 on both lobes(they had his notes and copies of old cams, along with the masters).
So recently I had another set of cams made and noticed that they weren't any different in measurement than the set of intakes in my basement. So I went about putting together a home made cam duration/lift device to measure them(patent pending) and it was interesting.. video is below.. I welcome feedback. One of my findings was that these cams are not measured at .05..( and yes the indicator is a Bic Pen Cartridge held on by painters tape)
https://youtu.be/kxLuGWYe4PA