Dyno day for the restored 90....

[Corvette95]

Official sheets are being emailed... but today was 386.2

This is with a Haibeck canned tune, I think I can break 400 with a dyno tune

[DRM500RUBYZR-1]

Tune,,,,,schmuunne
forget all of that, we know they RUN.
However...
Your car looks FANTASTIC!
Well done!
:cheers:
Marty

[Corvette95]

Tune,,,,,schmuunne
forget all of that, we know they RUN.
However...
Your car looks FANTASTIC!
Well done!
:cheers:
Marty

Thanks Marty! :cheers:

[Corvette95]

maybe this will work..
https://www.facebook.com/stories/1506960906058874
https://www.facebook.com/BryantBrothersRacing

[Erik]

Damn impressive! What a gorgeous car.

[BlueDevlC7z]

Truly a gorgeous, well thought, restoration. I can stare at that beast all day. America still builds rockets in Alabama!!!

[Paul Workman]

What was the upper RPM limit on the graph? Looks to me like it wasn't quite done yet! (Beautiful curves tho - and the car ain't bad neither! LOL!)

[Top Toy]

Nice power curves! What was the solid red line? Other mods besides the chip? Beautiful car! Torch red?

Sent from my SM-G986U1 using ZR-1 Net Registry mobile app (http://r.tapatalk.com/byo?rid=90383)

[Corvette95]

What was the upper RPM limit on the graph? Looks to me like it wasn't quite done yet! (Beautiful curves tho - and the car ain't bad neither! LOL!)

I saw that. I went past 7k on each pull and Batee just calibrated my tach, I do wonder if I should have pushed it morel

[Paul Workman]

I saw that. I went past 7k on each pull and Batee just calibrated my tach, I do wonder if I should have pushed it morel

After completing the "500 package" (510ish) I had Marc bump my rev limiter to 7500 b/c I was hitting the 7100 limiter 100 yards before I crossed the traps in the quarter mile. I'm thinking you may have that same issue too, if quarter mile runs are in the plan!

My scanner has a tach readout, so I calibrated my own tach - built a resistor bridge to correct the stock part that deteriorates over time. Batee now offers the replacement part for a "DIY" calibration, if so inclined. (Pretty easy to do if you have the iron, etc., to remove the solder and replace it with the new part.)

[Pete]

Does look like he shut it off early.
4th gear at 7k rpm is 150mph w/3.45 rear gears that says 138.

Pete

[Corvette95]

Yeah, isn't the redline 7200 rpm? I didn't want to just hammer it on the dyno . Maybe could have broke out a few more ponies? I don't know if Marc's chip without specifically asking for it raises redline.