haibeck chip install???

[zr-1assassin]

hey guys, got the chip the other day and want to make sure i install this correctly. disconnect the negative,open the bottom of the ecm, switch chips,replace ecm and connect the neg cable back and done! is this correct??? any tips? thanks:thumbsup:

[Aurora40]

Yup, that's pretty much it. There are clips of sorts on the sides of the PROM that hold it in. Just push then to the side and the chip will lift out a little. Push them back towards the PROM when you put the new one in. If you've ever added memory to a computer, it's similar to that. It's very easy.

[zr-1assassin]

Yup, that's pretty much it. There are clips of sorts on the sides of the PROM that hold it in. Just push then to the side and the chip will lift out a little. Push them back towards the PROM when you put the new one in. If you've ever added memory to a computer, it's similar to that. It's very easy.thanks.....got it done:thumbsup:

[Hammer]

thanks.....got it done:thumbsup:

How do you like it so far?

[zr-1assassin]

How do you like it so far?i do notice a difference in idle and it seems to get to 7000 a little faster. all in all i do notice a change:thumbsup:

[mrzzzr1]

What performance profile did you have it programed to?

[zr-1assassin]

What performance profile did you have it programed to?just the entry level chip, all the little things it does. mark could tell you a lot better than i:mrgreen:

[Hammer]

What performance profile did you have it programed to?

Standard for me too.