NEW GM 84-90 Hood and Fuel Emblems plus couple misc items (trades considered)

[Corvette95]

I have two brand new never installed in GM boxed metal front and rear emblems for 84-90. $50 plus shipping.


I have a zero mile NOS A-pillar weatherstrip, zero miles bought 2020, out of the box has a piece of the outer latex cover missing about 3 inches long (outer cosmetic only- seal is intact) $75 plus shipping

NOS Driver side door weatherstrip, just like above, GM NOS bought 2020, a 3 inch piece of the cosmetic outer latex missing, does not effect sealing. $50 plus shipping

Both weatherstrip has the gm stickers on them as from the factory. Both are new /zero miles.

Will update with pics tomorrow. Probably add a few items.

LT5 Airbox/duct $150 +shipping .

16 Ford injectors / both primary and secondary..ohm'd and pressurized leaked checked $100 + shipping.

2 (primary and secondary but) fuel pumps with receipts, bought this year, installed but zero miles on them, Lingenfelters came in (were on 6 month back - ordered) while car was being upgraded $100 plus shipping for both (can provide purchase receipt if needed..lifetime warranty I think).

Nice seat of red leather sport seat covers, passenger is in VERY good condition, Driver is good other than bolster needs to be repaired. $150 for shipping. (90 Flame Red) (out of 28k car)

91-95 GM 3 piece front air dam.spoiler - scratched and well used, can be cleaned up for NCRS. $25 plus shipping.

MAY trade for 90 passenger side headlamp motor assembly, 90 ZR-1 radio bezel - cosmetics don't matter, 90 power key with or without power key, 89-93 shift boot WITH lockout ring (not stripped allen key), ZR-1 antenna grommet , driver side forward PVC pipe, 90-93 turn signal switch (base or ZR-1), 90 J55 PBR front brake pads- usable condition, 91-95 rear "CORVETTE" (ZR-1) specific larger emblem-ANY color, ZR-1 rear bumper - good condition ( which means a few small cracks but no major prior repairs) - prefer in SouthEast USA for pickup

UPDATED with weatherstrip pictures, scroll down for other pictures

[lfalzarano]

Sent a PM


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)

[Corvette95]

Updated with pictures

[-=Jeff=-]

I would like to see pictures of the leather, I have a pair of seats that could use them.

90-93 turn signal switch, which part do you need?

[Corvette95]

I would like to see pictures of the leather, I have a pair of seats that could use them.

90-93 turn signal switch, which part do you need?

Need the whole turn signal switch... here is a link to my seats I posted..
http://zr1.net/forum/showthread.php?t=31679&highlight=leather+seats

[-=Jeff=-]

Need the whole turn signal switch... here is a link to my seats I posted..
http://zr1.net/forum/showthread.php?t=31679&highlight=leather+seats

So you need the piece that surrounds the column shaft that engages and disengages the signal? Along with the stalk? I assume you need the metal part that allows the stalk switch the signal switch? If you need the part that holds the stalk then you need the wiper switch..

So are those all the parts you need? I would consider a trade, but need the know what exactly you need to make sure I have it

[Corvette95]

So you need the piece that surrounds the column shaft that engages and disengages the signal? Along with the stalk? I assume you need the metal part that allows the stalk switch the signal switch? If you need the part that holds the stalk then you need the wiper switch..

So are those all the parts you need? I would consider a trade, but need the know what exactly you need to make sure I have it

I don't have an actual picture but DISREGARD any part that says 89-96, what I need is 90-91 specific..... see here , 94-96 WILL NOT INTERCHANGE. Thanks

https://www.gmpartsgiant.com/parts/gm-switch-as-1995974.html

[-=Jeff=-]

Ok you need the actual turn signal electrical switch. I have several let me see if they have part numbers

[Corvette95]

EMBLEMS SOLD!!!!