BOSE relay access

[Stratos]

Hi
I have a 1991ZR-1 I am trying to change Bose relay (relay that send 12V to each speaker AMP) :Eagle:do you have to remove carpeted low dash and aluminum knee bolster both?
Thank You

[secondchance]

If you are referring to CDM, yes. Passenger side.

[Z51JEFF]

If you’re talking about the CDM controller once you get the bush panel off. Take out the pass seat,get on your back,look up into the hole where it resides then relieze what a total pain in the a$$ the jobs going to be and have somebody else do it! I work on my own cars and this was one of the biggest pain in the a$$ I’ve ever done.

[billschroeder5842]

Mine took over four hours with two weeks of recovery time for contorting my back.

Worst project I ever did on the car.

[Dynomite]

Post 139 - Bose Speaker Amps and CDM Replace (http://forums.corvetteforum.com/c4-zr-1-discussion/3005470-tech-info-lt5-modifications-rebuild-tricks-500-hp-7.html#post1585219757)

[Stratos]

Thank You for the quick response actually relay that send 12V to each speaker AMP trying to change

[geezer]

Left hand lower trim pad
Driver's knee bolster
relay & wiring cable located at the lower right side of the I/P carrier
push relay & cable away from carrier & pull down from retainer.