PDA

View Full Version : Intake gasket sets?

ssrszz4
03-16-2018, 03:43 PM
Which do you use the 1/32" or 3/32"?


Sent from my XT1585 using Tapatalk
Jagdpanzer
03-16-2018, 05:33 PM
I prefer Jerry’s thicker 3/64” plenum gaskets.


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)
MuRCieLaGo
03-16-2018, 07:03 PM
I suggest you buy a couple of pairs at a time.

I've owned the car for 3 years/5,000 miles and I bought my 4th & 5th pairs wednesday.
Dynomite
03-16-2018, 07:24 PM
I use the thinner Plenum Gaskets 1/32" and I have TB Coolant Blocked at Injector Housing on ALL ZR-1s :thumbsup:
Ozruss90
03-18-2018, 04:55 PM
Could someone please explain why there are different thickness gaskets available? Does it depend on the year model, that they are a different thickness???
Cheers🇦🇺
MuRCieLaGo
03-18-2018, 05:07 PM
No.

From what I understood, the only advantage of 3/64'' is that they may be re-usable after a plenum removal, compared to 1/32''.
Ozruss90
03-18-2018, 05:17 PM
Thanks for clearing that up. When the time comes that l need to order, l now know l don’t need to order a specific thickness gasket set.
Wigert
03-19-2018, 03:16 PM
Sorry if I am hijacking the thread but on this topic I was wondering if someone of you could till me if the plenum gasket is enough or if an additional sealant is needed? When I had my car at the shop last year the mechanic also put some red sealant in addition to the gasket... I am not sure what that was...

Skickat från min GEM-701L via Tapatalk
Dynomite
03-19-2018, 04:03 PM
I have Throttle Body Coolant blocked at Injector Housings and do not use anything on 1/32 Plenum Gaskets.

Set Plenum in Place making ALL electrical and vacuum connections and then slide gaskets in place (lift Plenum just enough to slide gaskets in place).

I tighten Plenum SS Allen Head Bolts tight but not too tight and then check them once in a while (less than what book calls for as I have no coolant to TB) :D


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)
Wigert
03-20-2018, 02:39 PM
I have Throttle Body Coolant blocked at Injector Housings and do not use anything on 1/32 Plenum Gaskets.

Set Plenum in Place making ALL electrical and vacuum connections and then slide gaskets in place (lift Plenum just enough to slide gaskets in place).

I tighten Plenum SS Allen Head Bolts tight but not too tight and then check them once in a while (less than what book calls for as I have no coolant to TB) :D


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)Thanks for the input Dynomite!

Skickat från min GEM-701L via Tapatalk