A moron needs some help.

[Z51JEFF]

I've got a spare alternator I tore apart to rebuild now can't remember what order the 3 collars or spacers go,there are 2 that go on each side of the bearing and one between the fan and pulley. Anybody got the info on this? I've searched the net for a diagram,schematic but can't find anything. Thanks.

[A26B]

Scroll down in this thread for a picture

http://www.zr1.net/forum/showthread.php?t=27876

[Z51JEFF]

Scroll down in this thread for a picture

http://www.zr1.net/forum/showthread.php?t=27876

Thanks Jerry,that's the one.

[conesare2seconds]

Edited, somehow posted in this thread instead of the hypothetical restoration thread, oops.

[WVZR-1]

Scroll down in this thread for a picture

http://www.zr1.net/forum/showthread.php?t=27876

In that snapshot Jerry this would be GM SPO info for the spacers/collars

.396 is actually 10mm x 25.5 diameter GM# 1978064 (WAI 46-1601-1)

.232 is actually 5.8mm x 25.5 diameter GM# 1985999 (WAI 46-1617-1)

If a person were needing these the WAI information would likely be used by all after-market vendors.

[A26B]

In that snapshot Jerry this would be GM SPO info for the spacers/collars

.396 is actually 10mm x 25.5 diameter GM# 1978064 (WAI 46-1601-1)

.232 is actually 5.8mm x 25.5 diameter GM# 1985999 (WAI 46-1617-1)

If a person were needing these the WAI information would likely be used by all after-market vendors.

You are amazing!

[WVZR-1]

Knowing the dimensions of these two if you were to disassemble a CS144 for an LT5 the 3d on the rotor shaft behind the bearing would be the "other than".