WTB soon: Dual Mass Flywheel (LT1)

[jay23ls]

My first ZR1 forum post! :o Sorry for posting about a non-ZR1, this part isn't made anymore for the LT1 C4 so Im searching all around for it.

Been researching flywheel stuff since my clutch is getting replaced at a shop (couldn't do it myself right now). Some have said I'll def need a new flywheel, others including Jim from Power Torque Systems says no way to tell w/o looking/testing. So I'm starting the search now in case it cant be cleaned/resurfaced/machined etc.

Also, overall more ppl have advised against going single mass than the ones who favor it. Will do it if I cant locate a DMF or the price is very high.

She's a 94 LTI 6 speed. Thank you.

[LGAFF]

http://www.powertorquesystems.com/

check with jim

[RICHARD TILL]

I have an original flywheel from a 92 LT1 6 speed. Been on the shelf since 96.

[jay23ls]

http://www.powertorquesystems.com/

check with jim

Thanks. I checked w/ him earlier last week and he has just one.. brand new one that's much too pricey for me well probably for anyone lol

[jay23ls]

I have an original flywheel from a 92 LT1 6 speed. Been on the shelf since 96.

Great, PMed yah

[Corvette95]

FYI, I one of my 6speeds (95) a few years ago, I replaced the work dual mass clutch with a single mass and clutch set up from ALL the major vendors, could never get any of them work smooth (I expected additional noise), has chatter problems, release problems, all kinds of problems, cant remember who's all clutches I used, I know I started with SPEC, had same installer for first two then had a car company trailer my car to Jim Dorn who installed the last one, it was acceptable but never right. So unless you want the performance gains of a single mass (and it is a big improvement when right minus the noise), I would go back with the best used dual mass I could find if I couldn't find a NOS. Just my opinion.

[HAWAIIZR-1]

If you have not found a flywheel yet, here is one recently posted:

http://www.corvetteinternational.com/showthread.php?t=539254

The clutch fork and hose are no longer available, but I believe he still has the rest of the items.

[mike100]

This posting is probably past its use by date, but I have a good used one for cheap. (LT1)

The part can be picked up in or near North San Diego Co, but I do have it in a HD box that could be shipped.