Adjustable ARB End Links

[RussMcB]

Does anyone know if aftermarket adjustable sway bar end links are available?

I just noticed the bushings in my rear links are NG. I need to replace them, so I thought I'd see if they are available with adjustable lengths (so I can make sure there is no pre-load).

I checked a few Corvette vendors, and Googled for a few minutes and haven't come across any yet.

Thanks.

[JimZRyd]

I've been looking for these as well, figured I'd do this since I'm installing coilovers and poly bushings and such. I think DRM had some but was very expensive for end links. Haven't found any vendors otherwise. There was a guy on the Corvette Forum that made his own heim joint end links using generic pieces. Thought I might go that route one day but for now just switched the bushings in the stock stuff.

[1991ZR1]

Try emracingcorp.com. I think they used to be called Exotic Muscle.

[RussMcB]

Try emracingcorp.com. I think they used to be called Exotic Muscle.Nice!

http://emracingcorp.com/scripts/prodList.asp?idcategory=28&curPage=5&sortField=sku

Thank you very much!

- Russ

[JimZRyd]

That was them. Exotic muscle. My mistake.

[Shrek]

Russ, If I can find all my stock parts, I'll have a full set of front and rears available.
I'll go through all my boxes of crap sometime this week.

:cheers:
Jeff

[lbszr]

Does anyone know if aftermarket adjustable sway bar end links are available?

I just noticed the bushings in my rear links are NG. I need to replace them, so I thought I'd see if they are available with adjustable lengths (so I can make sure there is no pre-load).

I checked a few Corvette vendors, and Googled for a few minutes and haven't come across any yet.



Thanks.

The sway bar bracket on one side of where it attaches to the knuckle can be shimmed up to make no preload and longer bolts are needed. Front can be shimmed where it attaches to the frame.