stage one cam specs

[aafc]

OK,
So i'am sitting here 12 days after having my right shoulder replaced. and
someone asked me what are my cam specs on my 368 cu in stage one
cam motor ( 1990 ). So how do if out or can someone tell me.
As far as my shoulder goes, during real good I go in tomorrow for first
PT evaluation. The only bad thing is i can't drive the ZR-1 for 3 weeks or more.
thanks,
John
1990 white/black auto ( 4l80E ) eq ZR-1

[HAWAIIZR-1]

OK,
So i'am sitting here 12 days after having my right shoulder replaced. and
someone asked me what are my cam specs on my 368 cu in stage one
cam motor ( 1990 ). So how do if out or can someone tell me.
As far as my shoulder goes, during real good I go in tomorrow for first
PT evaluation. The only bad thing is i can't drive the ZR-1 for 3 weeks or more.
thanks,
John
1990 white/black auto ( 4l80E ) eq ZR-1

John,

I guess it depends on who designed the Stage I cams you have. If South Georgia Corvette (Aaron Scott), it will be: lift .420, duration
230 degrees at .050 for both intake and exhaust cams

[aafc]

Craig,
thanks for the information , The motor was built by Arron Scott @ SGC.
back in Jan 2009 .I cannot find my build sheet for the information. The
6-speed was replaced with an auto back in Aug 2004.She has run the best of 11.58 @ 120.00 in the 1/4 mile.
Thank you
John
1990 white/black #2546
one of a few auto ( 4l80E ) eq. ZR-1's

[HAWAIIZR-1]

You're welcome John. I've always admired that car of yours. I have the same cams are the only reason I knew the specs. Regards, Craig