4 brackets from inj. Housings to fuel rails..

[Vette73]

Any members have a photo of how to mount the brackets from injector housings to fuel rails? A 10 mm bolt attaches to the inj housing and the bracket gets screwed onto the fuel rail with a single hex screw....

That's simple enough but, my question is I'm sure there's anorher bracket that goes along with it......I forgot how it was situated when I took off the fuel rails to do the porting....I have four of these brackets, there about a half inch long and I'm sure they go with them but can't seem to figure out how they go.....

[secondchance]

http://www.tonkinonlineparts.com/showAssembly.aspx?ukey_assembly=839371

Hope this helps.

[Vette73]

http://www.tonkinonlineparts.com/showAssembly.aspx?ukey_assembly=839371

Hope this helps.

Son of a bitch...That's where those other brackets go....
The ones I was talking about go in the rear of the fuel rails where the lines
Are connected......

I have the same page in a service manual but it is not detailed like the one you
Posted.....

Hey man thanks so much.....Big help..

[secondchance]

Glad it helped.