Request - Master Cylinder Push Rod Diameter

[BigIke]

Hey guys, the ZR-1 is still on the lift. Installing the RAM conversion we observed that the slave cylinder fittings make contact with the pressure plate. So I need to limit travel.

I'm going to limit travel at the MC push rod by installing a split-clamp on the rod. Just need the diameter so I order the right part.

I'm waiting on a few parts to complete assembly so I won't be near the car for the next few days.

Thanks for your time,
Jay

[Corvettes White]

0.291" dia. Part with reservoir. Not sure that is what you were asking for. George

[BigIke]

That's it, the MC push rod. Thanks, going to try and put a small split clamp around the shaft near the eye to limit hydraulic release bearing (HBR) travel.

http://ecx.images-amazon.com/images/I/7155PAUkXaL.jpg

Got a 7mm steel and a 1/4" teflon split clamp.

Thanks again,
Jay

[Corvettes White]

Welcome.