WTB Driver Side Quarter Molding

[Jagdpanzer]

I busted mine off again getting out of the car the other day and this time its beyond repair. Its the short one that fits between the door and rear wheel well. Goes under GM P/N 10174881 and fits 91-95 ZR-1s. Need the left one but will take both left and right sides if you have them.

[GOLDCYLON]

Phil Ive been looking for you as well. No good news yet.. Darn doglegs are HTF unless its like one below :mad:


http://www.ebay.com/itm/Corvette-NOS-Drivers-Side-LH-Rear-Quarter-Panel-Trim-Moulding-1991-1996-/151413472255?fits=Year%3A1991%7CModel%3ACorvette&hash=item2340f23bff&vxp=mtr

[Jagdpanzer]

[QUOTE=GOLDCYLON;226066]Phil Ive been looking for you as well. No good news yet.. Darn doglegs are HTF unless its like one below :mad:

If nothing turns up I might try my hand at shortening a base C4 quarter molding which appear to be a lot more plentiful than ours. Wish me luck.

[z proud]

I can make a call to see if the person I got the 25 or so from has any more, give me a day or two to get an answer.

:handshak:

[Z51JEFF]

[QUOTE=GOLDCYLON;226066]Phil Ive been looking for you as well. No good news yet.. Darn doglegs are HTF unless its like one below :mad:

If nothing turns up I might try my hand at shortening a base C4 quarter molding which appear to be a lot more plentiful than ours. Wish me luck.

The none Z part is about 3/4 of an inch longer but can be made to work. Send me the part and I can shorten it for you. I can even paint it if you provide the material.

[z proud]

I spoke to him, he is checking, but he thought he sold me all he had.

Bill

Did you check wit the lead from Florida I sent you?