Thottle Cable Adjustment?

[Scrrem]

While doing our final checks yesterday before I fired up the new motor, it was discovered that my throttle plates are not opening fully when I mashed down the accelerator pedal. Is there any kind of adjustment on the cable for a 90? The later cars have an ajustment up by the ASR, I didn't see anything on mine.
Rich

[XfireZ51]

While doing our final checks yesterday before I fired up the new motor, it was discovered that my throttle plates are not opening fully when I mashed down the accelerator pedal. Is there any kind of adjustment on the cable for a 90? The later cars have an adjustment up by the ASR, I didn't see anything on mine.
Rich

This may sound stupid but have you checked to make sure cable is fully seated in throttle cam? Guess why I know that?

[efnfast]

Well, lets hope the car has gobs of power with the throttle only part way open. 'magine when it opens all the way!

[Scrrem]

This may sound stupid but have you checked to make sure cable is fully seated in throttle cam? Guess why I know that?

It seamed to be when I re-installed it but I'll check it again.
Rich

[secondchance]

You must have stretched the cable with all that pedal mashing!
Should be able to rig something at the pedal.

[Demps]

There is on a 95. I'm pretty sure the 91 has one too. Don't know about 90 but here goes: Trace cable and see if it has a block type section. If so, there will be a hard plastic plunger or release. Depress pedal all the way then depress the plunger. I'll look in svc manual.
Ted

[We Gone]

Ted I don't believe the plunger adjustment on the throttle cable came out untill ASR. None on my 91 .. 93 has it.

[Demps]

Concur. No talk of adjustment in 90 svc manual. Just references no binding and seat correctly in pedal. There is however description for cruise.
Ted

[XfireZ51]

Ted,

That's only on ZRs w ASR. 92-95. 90-91 are twin cables instead of 1.