View Full Version : Bad injectors or vacuum leak?
gen2rt
08-20-2014, 01:49 PM
I have a 1994, 19,000 miles, haibeck intake & port polish, headers.
Car suddenly has no bottom end, meaning bad stumble/dies at idle, when I get into it everything is fine. Since the car sits a lot my initial thought was bad primary injector(s). After searching forum, vacuum leak also looks to be a possibility. Looking for input from anyone experiencing something similar.
Thanks,
Jack
Kevin
08-20-2014, 01:52 PM
with the miles I'm going to say injectors. a vac leak will cause the car to fall flat high in the rpm band
LGAFF
08-20-2014, 02:03 PM
make sure your MAP sensors are connected
Ccmano
08-20-2014, 03:51 PM
make sure your MAP sensors are connected
I'm with Lee... fuel pump possible too. My money is on the MAP sensor tho.
H
LGAFF
08-20-2014, 05:05 PM
I was having an issue at cruise......had rotted rubber on the MAP sensor that was not visible until close inspection....Fuel Pressure Regulator too
Demps
08-20-2014, 06:04 PM
Jack,
Where are you located?
Ted
tccrab
08-20-2014, 07:01 PM
Map sensor hose is first guess.
Does it smoke on startup?
Second guess is fueling, either fuel pumps or filter.
Since it's a '94, injectors aren't as likely to be at fault as if it were a '90 or '91.
'Crabs
gen2rt
08-22-2014, 12:25 AM
Thanks for the responses. I'll try the MAP sensor hose/connections. The ZR is parked in Colorado, I mostly live in Reno though. I'll hold off ordering new injectors and will dig into the MAP sensors when I get back to CO (in a couple months). I hope that's what it is, would rather not get into a plenum pull if I don't need to.
If the MAP sensor is ruled out, I'll start looking at the other suggestions.
I'll post back here what I find for reference.
Jack
XfireZ51
08-22-2014, 12:41 AM
Thanks for the responses. I'll try the MAP sensor hose/connections. The ZR is parked in Colorado, I mostly live in Reno though. I'll hold off ordering new injectors and will dig into the MAP sensors when I get back to CO (in a couple months). I hope that's what it is, would rather not get into a plenum pull if I don't need to.
If the MAP sensor is ruled out, I'll start looking at the other suggestions.
I'll post back here what I find for reference.
Jack
Jack,
I'll be in Denver next weekend. Where is it in CO. Darby and I can check it out.
gen2rt
08-23-2014, 04:29 PM
Xfire,
PM sent.
thanks,
Jack
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.