PDA

View Full Version : DRM coil over install.

cvette98pacecar
08-05-2014, 11:21 AM
I reserved the first ten post for step by step instructions.
cvette98pacecar
08-05-2014, 11:22 AM
Reserved 2.
cvette98pacecar
08-05-2014, 11:22 AM
Reserved 3.
cvette98pacecar
08-05-2014, 11:23 AM
Reserved 4.
cvette98pacecar
08-05-2014, 11:23 AM
Reserved 5.
cvette98pacecar
08-05-2014, 11:24 AM
Reserved 6.
cvette98pacecar
08-05-2014, 11:24 AM
Reserved 7.
cvette98pacecar
08-05-2014, 11:25 AM
Reserved 8
cvette98pacecar
08-05-2014, 11:26 AM
Reserved 9.
cvette98pacecar
08-05-2014, 11:26 AM
Reserved 10.
Jitse
08-06-2014, 05:45 AM
I will start soon with my DRM coil-over, swaybars, and Banski rear suspension upgrade too. Looking forward to see your reports :-) and if there is interest I add some pictures here from the progress.
BennieC.
09-27-2014, 11:35 AM
This is also in my wish list. Waiting for Randy @ DRM to get back with me.
Jitse
10-07-2014, 12:51 PM
Last week, I started with the upgrade.
Everything is now dismantled and cleaned, I want to make the groove in shock absorber for the snap-ring too keep the sleeve in position. Did somebody know the wall thickness from the Bilstein shock?

I think to go 0.4 mm deep. Any recommendation ?

I like to change the bushings for the front End Control Arm, the energy suspension catalogue item #3.3142 looks correct for it. With a press it's not too big issue to change them.....

Later on some pictures from my progress.